| TEST | PROCEDURE | REQUIREMENT
SHALL NOT EXCEED |
| Resistance | 
0.005 Ohm |
- |
| Operating Temperature | -55°C to +155°C | - |
| Maximum Current | 5 Amp | - |
| Maximum Working Voltage | 300 V DC | - |
| Maximum Overload Voltage | 600 V DC | - |
| Dielectric withstanding Voltage | V-Block
Method, 3 x Limiting Voltage
Duration - 1 minute |
± 0.5% |
| Insulating Resistance | V-Block
Method, DC 500 V
Duration - 1 minute |
± 0.5% |
| Temperature Cycling | 5 Cycles of -65°C, 25°C, 150°C, 25°C | ± 0.5% |
| Short Term Overload | 2.5
x rated voltage Duration - 5 seconds |
± 0.5% |
| Load Life | Rated
Voltage at 70°C ambient Duration - 1000 hrs. Condition : 1.5 hrs. ON 0.5 hr off |
± 1% |
| Damp Heat ( Steady State) | 40°C,
95% relative humidity Duration - 56 days |
± 1% |
| Robustness of Terminations | Tensile
: 10N Dur. : 10 seconds Bending : 180°, 3 Bends, Torsion : 3 Rotation of 360° each |
No Visible Damage |
| Shock | 1 Km/S² | No Visible Damage |
| Vibration ( High Frequency) | 10 to 2000 Hz : 200m/s² | No Visible Damage |
| Solderability | Dip
Method, solder Bath Temp : 230°C ± 5°C Duration - 5 seconds |
95%
of Tested Surface Covered |
| Resistance to Solvents | Solvent
: Trichloroethylene Duration - 1 minute |
MIL
- STD 202 Method 215 |